Technicolor COM2000 Betreibershandbuch PDF herunterladen (Seite 98)

The Messages are:

0 = Download new DCI401MCS software

3 = Feature enable/disable

4 = Reset DTA user settings (ratings locks, …)

5 = Tune to a specified Major_Number – Minor_Number channel

6 = Scan for new channels

7 = Display text for a few seconds on the TV

9 = Set which channel is the EPG channel

10 = Set site specific error messages indicating who to call for support

11 = Send logo file for use in the user interface

Receiver_ID – This field is the unique receiver ID number of the target for the command. The

RID can be found in FIXME. A RID value of 0xffffffff represents a broadcast RID and all

receivers connected to the network will respond to the command.

RF channel – This field is the RF channel the command message will be broadcast on.

Bank – This field only applies to the ‘Download Now’ message and specifies which of the 2

firmware banks in the device to store the new SW image in.

Filename – If the command is Message Type 0 or Message Type 11 this field is the name of the

new SW image or logo file to be sent to the 401.

TFTP_IP – If the command is Message Type 0 or Message Type 11 this field is the IP address

of the TFTP server that is going to send the file.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 127 128

Keine Kommentare

Technicolor COM2000 Betreibershandbuch Seite 98