Technicolor COM2000 Betreibershandbuch PDF herunterladen (Seite 72)

chassis, this can be used to identify each card in the system. See Section 4.1 on how to assign

unique identifiers to multiple chassis within a system.

Slot – This field identifies the card’s location within a chassis, numbered 1 through 6.

CardIP – This field shows the IP address of the COM46 card that resides in the chassis and slot

combination to its left. This field is also a link to see the Syslog for that card.

RID –This field reports the DIRECTV Receiver ID, or RID. This value is the first of two

parameters required to obtain authorization on the DIRECTV network.

CAM_ID – This field reports the DIRECTV CAM ID. This value is the second parameter

required to obtain authorization on the DIRECTV network. You can click on the hyperlink in

this column to be taken directly to that card’s CAM Log (see Section 6.2.4 for more information

on reading a card’s CAM log).

Serial_Number – This field contains the unique electronic serial number of the board assigned

at the time of manufacture.

Authorized – This field reports whether the COM46 card’s CAM has been authorized. A value

of ‘1’ indicates that the card has been authorized, thereby enabling the card to receive DIRECTV

programming. A value of ‘0’ indicates that the card has not been authorized.

Paired – This field reports the pairing status of the CAM card. In order to be capable of

receiving an authorization to the DIRECTV network, the RID and CAM data must first be

paired. If this has not happened, then the card cannot be authorized until the pairing is resolved.

A value of ‘1’ indicates that the RID and CAM are successfully paired; a value of ‘0’ indicates

that they are not.

Note: Refer to Section 10.4 for more information if you notice a

card that has a value of ‘1’ under both the “Authorized” and

“Paired” columns but is not streaming video properly.

SW_Version – This field reports the software version that currently resides on the COM46 card.

All cards that have a similar web interface to the one described in this document will have a

version number of at least ST03.02.07. The examples given have been taken from cards that are

running the ST03.02.08 software release.

Up_Time – This field gives an indication of how much time has elapsed since the card was last

rebooted or powered up.

Upgrade – By checking this box for a particular card, you will make each of the fields at the

bottom of the screen active for that card. This allows you to upgrade multiple cards at a time.

Figure 44 below shows in detail the upgrade section available on the PairingInfo page.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 127 128

Keine Kommentare

Technicolor COM2000 Betreibershandbuch Seite 72