Technicolor COM2000 Betreibershandbuch PDF herunterladen (Seite 103)

103

Figure 62 – COM46 Multi-card Upgrade Feature

7.3 Upgrading COM46 Firmware

DO NOT turn off power or unplug a card that is updating its SW image. YOU WILL

create a doorstop.

This section will guide you through the procedure for upgrading your COM46 cards. There are

two different ways you can go about doing this. The first method is a single-card upgrade, which

requires the use of the file transfer utility located on the Advanced Edit page (see Section 6.2.6).

The second and preferred method is a multi-card upgrade, the controls for which are located at

the bottom of the PairingInfo page (see Section 6.5).

For both of these methods, the “Usage” option should be on ‘2 = SW_Upgrade.’ The

‘Server_IP_Address’ will be the device that contains the upgrade file (your PC, file server, or

COM46 card). The “Filename” will be the name of the upgrade file (e.g.

“COM46_ST03.02.09.bin”). It is recommended that you retain the original filename of the

update file you have been issued to avoid confusion later on. The mode determines whether the

card tries to contact a FTP or TFTP server.

To use the single card upgrade method, go to the File Transfer section of the Advanced Tune

page (see Section 6.2.6). Enter the IP address of the server and filename of the new image as

indicated above and press the Submit button. The same method can be used to enter a license file

on a single card for an SD to HD upgrade or other feature upgrade (see Section 7.4) only the

Usage field should be set to ‘4 = License’.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 127 128

Keine Kommentare

Technicolor COM2000 Betreibershandbuch Seite 103