Technicolor COM2000 Betreibershandbuch PDF herunterladen (Seite 10)

1 INTRODUCTION

This document describes the processes and procedures for configuring the new Technicolor

COM2000 system. Users familiar with the previous generation COM1000 system will find most

of the screens and controls in the new system familiar as they are carried over from the

COM1000 with some minor adjustments for the increase from 2 to 8 tuners per receiver card.

There is also a new “Overview” tab in the GUI described in Section 6.3 which aggregates and

simplifies the controls for initial configuration of the system on site.

For new users and installers, the following sections will provide a brief overview of the system

hardware, an in-depth guide to the COM46 user interface, and descriptions of certain system

processes. Also included are several indices that cover common troubleshooting problems.

It is recommended that you read through the entirety of the manual, or at least review the main

sections before working with the system, as it contains some important pointers that may come in

handy during setup and maintenance.

The table below provides an explanation of some useful terms and device names that will be

referred to throughout the manual. You should use these terms to familiarize yourself with the

different aspects of the system before proceeding any further.

Table 1 – Definition of Terms

Term

Definition

ATSC8

An optional eight channel off-air ATSC receiver that may be connected to

and configured from a COM2000 system.

COM200

A legacy chassis that can support up to 12 receiver cards. This chassis

contains an integrated gigabit Ethernet switch and Ethernet Card, but

does not include other necessary equipment such as an edge QAM device

or RF distribution and signaling electronics. This chassis is forward

compatible with the COM360 chassis and can be used with both COM24

and COM46 cards, however COM46 HD cards should not be used with all

8 tuners enabled in any card slot except the slot marked 1 as the

integrated Ethernet switch is limited to 100 Mbps in all except the first

slot.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 127 128

Keine Kommentare

Technicolor COM2000 Betreibershandbuch Seite 10