Technicolor COM2000 Betreibershandbuch PDF herunterladen (Seite 24)

The COM360 chassis has one full and one partial card guide; the board is retained by the front

panel screws, which MUST be installed.

Install the QAM6 Board as follows:

1. Remove power from the chassis.

2. Install the QAM6.

3. Tighten front panel retaining screws.

4. Plug power cable back into the chassis.

4 GETTING STARTED

The COM2000 System is quite different from the stacked DIRECTV set-top box (STB) receivers

traditionally used in L&I rack installations. This is because the COM2000 does not natively

decode any audio or video, instead relying upon other devices in the system to decode and

display the MPEG streams it produces. Furthermore, the COM2000 does not have a native user

interface although it can be controlled and configured through the built in web server.

Controlling and monitoring the COM2000 requires a device with an Ethernet connection and a

web browser of your choice. The COM2000 only supports a direct wired Ethernet connection.

4.1 Setting up Multiple Chassis

For installations that require more than one COM360 chassis each chassis will need to be

assigned a unique chassis ID. This can be done by removing the back cover of the COM360 and

setting the DIP switches located on the backplane as shown in Figure 9. The chassis will ship

preconfigured from the TCH factory as chassis #1. If there are multiple COM360 chassis in a

system, they must be configured with different IDs or several of the IP addressing schemes will

work improperly possibly creating strange and unexplainable video routing and decoding

behavior.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 127 128

Keine Kommentare

Technicolor COM2000 Betreibershandbuch Seite 24