Technicolor ATSC-8 Betriebsanweisung PDF herunterladen (Seite 10)

Technicolor MCS

101 W. 103

Indianapolis, IN 46290

www.technicolor.com/mcs

From the EPG page, entering the following data from the examples above will give you the

expected results. Since DIRECTV program data typically only exists for “major” channels

broadcast over ATSC, the PSIP program data can only be applied to these channels. You will

see in the below example that the minor channels are given program names such as

WTHR_Local_Weather. No program data can be provided for these minor channels via the

Technicolor PSIP interface.

Channel 6.1 which was being sent to the QAM on port 17 would only be available on the RF

frequency the QAM is configured to. In our example, this happens to be 30.1 (see QAM

configuration in the Integrator’s Manual). We desire to have channel 6.1 be visible on the TV

on channel 6.1, so the above example will create this virtual channel for port 17, as well as

add the program data from DIRECTV channel 6, which in Indianapolis is the same channel.

Channel 6.2 is unable to be associated with program data, however, the virtual channel data

can be set so rather than on channel 30.2, the ATSC program can be tuned at virtual channel

6.2.

By using the 1.2.3.4 in the DestIP field, only PSIP is being generated and there will be no EPG

created. If EPG is desired as well as PSIP, the QAM IP and port number can be inserted in the

DestIP and DestPort fields respectfully.

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Technicolor ATSC-8 Betriebsanweisung Seite 10